ENGINE CRANKCASE (BLOCK)

FUEL INJECTORS (cont) - TM-5-3825-229-14P_344

ENGINE CRANKCASE (BLOCK) (cont) - TM-5-3825-229-14P_346

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
327

TM 5-3825-229-14&P 6-15. ENGINE CRANKCASE (BLOCK) THIS TASK COVERS: Equipment/Material Required: a. Cleaning Lubricating oil (Item 10, Appendix E) b. Inspection Cleaning Solvent (Item 13, Appendix E) c. Repair Detergent INITIAL SETUP: Personnel Required: 2 Tools Required: Equipment Conditions: Nomenclature Ref Conditions Shop Equipment, 5-6 Engine removed Auto Maintenance 5-10 Flywheel housing removed and Repair, Field 5-12 Oil pump removed Maintenance 5-13 Exhaust manifold removed 5-14 Intake manifold removed 6-4 Cylinder head and valves removed 6-5 Tappets removed 6-8 Idler gears and backplate removed 6-11 Pistons and connecting rods removed 6-12 Crankshaft removed 6-13 Camshaft removed a. Cleaning. WARNING Wear protective goggles when using the cleaning solvent. Avoid contact with the eyes. If contact occurs, flush eyes with cold water for 5 minutes and seek immediate medical attention. Dry cleaning solvent (PD-680) is both toxic and flammable. Avoid prolonged breathing of vapors. Avoid skin contact. Use only in a well-ventilated area. Keep away from open flame. Flash point of solvent is 138°F (59C). (1) Clean the crankcase with cleaning solvent (PD-680) and dry thoroughly. (2) Scrape all old gasket material from crankcase surfaces. (3) Use warm water and a detergent and flush the crankcase. Use rags and air pressure to dry crankcase. 6-46

Privacy Statement
Press Release
Contact