ENGINE CRANKCASE (BLOCK) (cont) - TM-5-3825-229-14P

ENGINE CRANKCASE (BLOCK) (cont) - TM-5-3825-229-14P_348

ENGINE CRANKCASE (BLOCK) (cont) - TM-5-3825-229-14P_350

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
331

TM 5-3825-229-14&P 6-15. ENGINE CRANKCASE (BLOCK) (cont) c. Repair (cont). (3) Gradually tighten puller nut until bearing (1) is removed from crankcase bore. (4) Remove the extracted bearing from the puller. Install puller on remaining bearings (1), except rearmost bearing, and remove intermediate bearings and front bearings (3). (5) Remove the rear bearing (1) by reversing the position of the puller so rear bearing is removed toward front of crankcase. CAUTION The camshaft bearings must be properly positioned in crankcase. Oil hole in bearing must line up with oil passage in crankcase. (6) Install the bearing on the puller. Align oil hole in bearing with oil hole in block for main bearing. 6-50

Privacy Statement
Press Release
Contact