TM 5-3825-229-14&P
3-7.
AIR CLEANER (cont)
f.
Loosen clamps (9) and remove elbow (10), air inlet tube (11) and elbow (12).
g.
Remove indicator (13) from elbow (14) and remove elbow (14) and pipe nipple (15) from manifold.
WARNING
Wear protective goggles when using the cleaning solvent. Avoid contact with the eyes.
If contact occurs, flush eyes with cold water for 5 minutes and seek immediate medical
attention. Dry cleaning solvent (PD-680) is both toxic and flammable. Avoid prolonged
breathing of vapors. Avoid skin contact. Use only in a well-ventilated area. Keep away
from open flame. Flash point of solvent is 138°F (59°C).
h.
Clean inside of cup (3), body (7) and cap (8) with cleaning solvent (PD-680).
i.
Inspect elbows (10 and 12) and air inlet tube (11) for cracks and damage. Replace elbows and tube if
unserviceable.
j.
Install pipe nipple (15) and elbow (14) in intake manifold. Install indicator (13) in elbow.
k.
Slide clamp (9) and elbow (12) on intake manifold.
I.
Slide air inlet tube (11) through rear of engine shroud and connect tube and clamp (9) to elbow (12).
m. Connect elbow (10) to air inlet tube (11) and air cleaner body (7) with clamps (9).
n.
Install element (6) into body (7) and install wingnut (5). Tighten wingnut securely.
o.
Install baffle (4) in cup (3).
p.
Install cup (3) on body (7). Take note of arrows and the word TOP on end of cover for correct positioning.
q.
Install clamp (2) over mating flanges of cup and body. Tighten thumbscrew (1) securely.
r.
Install cap (8) on inlet of body (7).
3-22
