UNPACKING AND CHECKING EQUIPMENT (Cont)

CHAPTER 4 ORGANIZATIONAL MAINTENANCE INSTRUCTIONS - TM-5-3825-229-14P_93

ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
76

TM 5-3825-229-14&P 4-4. UNPACKING AND CHECKING EQUIPMENT (Cont) b. If any exterior parts are coated with rust preventive compound, remove it with cleaning solvent (PD-680). c. Read and follow all instructions contained in DD Form 2258, attached to conspicuous part of water distributor. d. Un-cage brakes and drain all preservative fluids from engine, fuel tank, and air reservoirs. e. Inspect equipment for damage incurred during shipping. If equipment has been damaged, report damage on DD Form 6, Packing Improvement Report. f. Check equipment against packing slip to see if shipment is complete. Report ail discrepancies in accordance with DA Pam 738-750. g. A decal has been developed that warns of NBC exposure. It is to be positioned in a noticeable place on or near the air filter housing. To order the decal, refer to Figure 30 in the RPSTL. 4-5. SERVICING EQUIPMENT a. Perform preventive maintenance checks and services contained in Tables 2-1 and 4-1. b. Lubricate all points as shown in Lubrication Chart (refer to para. 3-2), regardless of interval. c. Schedule next preventive maintenance checks and services on DD Form 314, Preventive Maintenance Schedule and Record. d. Report all deficiencies on DA Form 2407, if deficiencies appear to involve unsatisfactory design. e. Perform break-in road test of 25 miles (40 kilometers) at maximum speed of 50 mph (80 km/t). Section III. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES Paragraph Title Page Number Number 4-6 GENERAL PMCS INFORMATION ............................................................................... 4-2 4-7 ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES........... 4-3 4-6. GENERAL PMCS INFORMATION To ensure that water distributor is ready for operation at all times, it must be inspected systematically so that defects may be discovered and corrected before they result in serious damage or failure. Table 4-1 contains a tabulated listing of preventive maintenance checks and services to be performed by organizational maintenance personnel. All deficiencies and shortcomings will be recorded, as well as corrective action taken, on DA Form 2404 at earliest possible opportunity. 4-2

Privacy Statement
Press Release
Contact