Table 4-1. Organizational Preventive Maintenance Checks and Services

ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES

Table 4-1. Organizational Preventive Maintenance Checks and Services (cont)

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
78

TM 5-3825-229-14&P 4-7. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES (cont) Table 4-1. Organizational Preventive Maintenance Checks and Services Q = Quarterly S = Semiannually A = Annually ITEM INTERVAL ITEM TO BE INSPECTED NO. Q S A PROCEDURES 1. BATTERY Test battery voltage and specific gravity (see para. 4-22). Refer to TM 9-6140- 200-14. 2. SUSPENSION Inspect semi-trailer suspension (rear axle assembly, springs, and torque rods) for leakage, cracks, or other damage. Report any damage to General and Direct Support Maintenance. 3. BRAKE SHOES a. Inspect brake shoe linings for wear. If lining is worn to within 1/16 in. (1.58 mm) of rivet heads, replace brake shoe (see para. 4-25). b. Adjust brakes and length of travel of brake chamber pushrod (see para. 4- 25). 4. AIR BRAKE SYSTEM With air system fully charged, apply a soap solution to all couplings, air lines, fittings, valves, and reservoirs. Make note of any leaks, damage, or loose connections. Tighten loose connections or make repairs as necessary (see para. 4-28 through 4-35). 5. WHEEL BEARINGS Adjust wheel bearings (see para. 4-36). 6. HUBS Inspect hubs for proper level of oil and replenish as necessary (see para. 4-36). 7. KINGPIN AND FIFTH WHEEL PLATE Clean kingpin and fifth wheel plate using rags and compressed air. Check kingpin for cracks, rust or other damage. If kingpin shows signs of damage, entire fifth wheel plate must be replaced. Notify Direct Support/General Support Maintenance. 4-4

Privacy Statement
Press Release
Contact