TM 5-3895-370-14&P
4-85. ENGINE WIRING HARNESS REPLACEMENT (CONT).
(14)
Remove three nuts (32), lockwashers (33), clamps (34), and extension wire harness (31) from main frame (35).
Discard lockwashers.
(15)
Cut plastic ties as necessary and remove extension wire harness (31) from four clamps (34).
b.
Testing. Test all wires for continuity. If wire registers infinity, replace wire.
c. Cleaning/inspection.
(1)
Clean out conduits with brush and wipe off wires and connectors with lint-free cloth.
(2)
Inspect harnesses and conduits for cracks, cuts, and bare spots. Replace harnesses and conduits if damaged.
(3)
Check individual wires for loose solder connections at connectors. Replace individual wires if damaged.
(4)
Inspect connectors for cracks and wear. Replace connectors if damaged.
d.
Installation.
(1)
Install extension wire harness (31) in three clamps (34) and install plastic ties as necessary.
(2)
Install three clamps (34) and extension wire harness (31) on main frame (35) with four lockwashers (33) and nuts
(32).
4-228
