TM 5-3895-370-14&P(13)Install wire harness (5) in two clamps (4).WARNINGAdhesive causes immediate bondingon contact with eyes, skin, orclothing and also gives off harmfulvapors. Wear protective goggles anduse in well-ventilated area. Ifadhesive gets in eyes, try to keepeyes open; flush eyes with water for15 minutes and get immediatemedical attention.NOTEApply sealing compound to threadsof two screws prior to installation.(14)Install two clamps (4) and two screws (3) onintake cover (6). Tighten screws 18 lb-ft (24Nm).(15)Connect connector (1) to shutdown solenoid (2).NOTEFollow-on maintenance:Connect engine extension wire harness toinstrument panel (para 4-85).Connect negative battery cable (para 4-84).Install front and rear engine panels (para3-6).Install fuel filter and fuel water separator(para 4-44).END OF TASK4-231
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
