TM 5-3895-370-14&P
NOTE
If rivets are holding handles and latch
brackets in place, it will be necessary
to drill out the rivets to remove
handles and latch brackets from
engine panel.
(3)
Remove two nuts (5), lockwashers (6), screws
(7), and two handles (3) from panel (2). Discard
lockwashers.
(4)
Remove two nuts (8), lockwashers (9), screws
(10), and latch brackets (11) from front panel (2).
Discard lockwashers.
(5)
Remove four nuts (12), lockwashers (13),
screws (14), and two rubber latches (1) from
engine frame (4). Discard lockwashers.
(6)
Remove two vibration isolators (15).
b.
Installation.
(1)
Install two vibration isolators (15).
(2)
Install two rubber latches (1) on engine frame (4)
with four screws (14), lockwashers (13), and
nuts (12).
(3)
Install two latch brackets (11) on front panel (2)
with two screws (10), lockwashers (9), and nuts
(8).
(4)
Install
two
handles
(3),
four
screws
(7),
lockwashers (6), and nuts (5).
(5)
Grasp handle (3) and install front panel (2) on
engine frame (4).
(6)
Install two rubber latches (1) on front panel (2).
END OF TASK
4-309
