TM 5-3895-370-14&P
c. Assembly.
NOTE
Coat all preformed packings and
backup rings with hydraulic fluid
prior to installation.
(1)
Install preformed packing (13) on piston rod (2).
(2)
Install cup (12) and backup ring (11) in piston
rod guide (8) (3) Install backup ring (10) and
preformed packing (9) on piston rod guide (8).
(4)
Install piston rod guide (8) on piston rod (2).
(5)
Install two backup rings (7) and preformed
packing (6) on piston (5).
(6)
Install piston (5) on piston rod (2).
CAUTION
Install locknut with label facing out.
Failure to comply will result in
damage to cylinder.
(7)
Install locknut (4) on piston rod (2). Tighten to
65 lb-ft (88 Nm).
(8)
Install retaining ring (1) on piston rod (2).
(9)
Install piston rod (2) as assembly on cylinder
body (3).
NOTE
Follow-on
maintenance:
Install
cylinder (para 4-141).
END OF TASK
5-183
