TM 5-4610-228-13
TM 08846A-13/1
Section II. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
4-4. COMMON TOOLS AND EQUIPMENT.
Refer to the Modified Table of Organization and Equipment (MTOE) applicable to your unit.
4-5. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
No special tools, TMDE, or support equipment are required for the five water distribution systems.
4-6. REPAIR PARTS.
Repair parts are listed in TM 5-4610-228-23P.
Section III. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
4-7. INTRODUCTION.
Organization preventative maintenance checks and services (PMCS) are found to be non-existent.
Section IV. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES
4-8. GENERAL.
This section contains troubleshooting information for locating and correcting most of the operating troubles
which may develop in your WDS. The troubleshooting procedures are listed in table 4-1. The table lists common
malfunctions which you may find during operation or maintenance of the water distribution systems or its
components. You should perform the tests/inspections and corrective actions in the order listed. Each
malfunction for an individual component, unit, or system is followed by a list of tests or inspections which will
help you determine corrective actions to take,
4-9. TROUBLESHOOTING PROCEDURES.
The symptom index lists the common malfunctions which you may find during the operation or maintenance of
the water distribution system. Use the symptom index for quick access to the troubleshooting procedures. This
manual cannot list all possible malfunctions that may occur, nor all tests or inspections and corrective actions. If
a malfunction is not listed (except where malfunction and cause are obvious) or is not corrected by listed
corrective action, notify your supervisor.
Table 4-1. Troubleshooting
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. Hose Leaks.
Step 1. Inspect for cut or cracked hose.
Replace or repair hose assy.
2. Hose Assy Coupling Halves Leak.
Step 1.
Step 2.
Inspect for damaged or missing coupling half gasket.
Install serviceable coupling half gasket.
Inspect for cracked coupling half.
Install a serviceable coupling half.
4-5
