CONTROL PANEL (TYPE 4)
SYSTEMS OPERATION
C
GENERATOR MOUNTED CONTROL PANEL
(TYPE 4 - CHANGE LEVEL 9 THRU 11)
INTRODUCTION
The uses of the generator mounted control panel are:
To help control the electric power made by the generator set.
To monitor (check) the operation of the generator set.
To help protect the generator set from damage caused by low oil
pressure, high coolant temperature, overspeed and overcrank.
To help with the transfer of electrical load to and from the generator set.
To help parallel two or more units onto the same bus.
IDENTIFICATION
The location of the control panel is on the top of the regulator housing.
This panel has a place for a heat switch and Prealarm module. The
shutdown indicators are relay lamp type. The control panel has either a
12 or 13 place model number on the panel nameplate. The model
number gives an indication of the control panel component part numbers.
Make reference to the Parts Book, GENERATOR MOUNTED CONTROL
PANEL, Form No. SEBP1068. The last digit (or two digits) of the model
number is the change level to which the panel was built.
WIRING
See the pages that follow for wiring diagrams, schematics and
photographs for identification.
210
