OUTPUT TRANSFER GEARS
Put 7M7260 -Liquid Gasket in the seal bore of
cage (22) and let it dry. Use tool group (A) and
a press to install the lip type seal in the output
shaft front bearing cage (22).
NOTE: The seal must be installed with the lip of the
seal toward the inside of the cage as shown.
Install O-ring seal (24) on cage (22).
Lower the temperature of bearing cup (23) and
install it in cage (22).
Install cage (22) and shims (25) in the output
transfer gears case.
Use tool group (B) and check the output shaft
end play. The end play must be .003 to .005 in.
(0.08 to 0.13 mm). If the end play is not correct,
add or subtract shims (25) from under cage (22)
to get the correct amount of end play.
Install yoke assembly (29), O-ring seal (28),
retainer (27) and bolt (26) on the output shaft.
Tighten bolt (26) to a torque of 80 ± 5 lb.ft. (110
± 7 Nm).