TM 10-413O-237-14
4-25.
ARMATURE GROUP REPLACEMENT/REPAIR (CONT)
a. Inspection
1 Remove two flywheel pulley mounting bolts and two lockwashers. Remove flywheel pulley.
2 Remove eight blower housing mounting bolts. Remove blower housing.
3 Move starter panel assembly aside.
4 Check armature group for dirt, oil, and rust. Clean as needed.
5 Check for loose wire connections on ignition module. If wire connection loose, replace armature group.
6 Check condition of spark plug cables. If cables damaged, replace armature group.
7 Install blower housing. Install eight blower housing mounting bolts and starter cable clamp.
4-60
