TM 10-4130-237-146-2.CYLINDER BLOCK ASSEMBLY REPAIR/OVERHAUL (CONT)25 Install governor shaft assembly. Install washer and E–ring on governor shaft.To prevent damage to oil seal while assembling crankcase cover, be sure touse oil or grease on sealing edge of oil seal. If sharp edge of oil seal is cut orbent under, seal may leak.New gasket sets include three crankcase cover or sump gaskets: 0.005,0.009,and 0.015 in. (0.13,0.23, and 0.38 mm) thick. Crankshaft end play should be0.002 to 0.008 in. (0.05 to 0.20 mm) with one 0.015 in. (0.38 mm) gasket inplace. If end play is less than 0.002 in. (0.05 mm), extra gaskets may be addedin various combinations to attain the proper end play.26 Apply a thin coating of oil or grease to sealing edge of oil seal. Wrap piece of thin paper around crank-shaft so that seal will slide easily over shoulder of crankshaft.27 Install new back crankcase cover gasket. Install back crankcase cover.6-23
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business