TM 10-4320-346-12&P
4-12.
HOSE ASSEMBLIES.
This Task Covers:
Repair
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Clamping Tool (Appendix B, Item 3)
Material's Required
Brush, Medium Bristle (Appendix F, Item 2)
Solvent, Dry Cleaning (Appendix F, Item 3)
Cloth, Lint-Free (Appendix F, Item 1)
Gaskets (Appendix I, Item 1) for 2.00 inch diameter hose.
Gaskets (Appendix I, Item 2) for 1.50 inch diameter hose.
Equipment Condition
Hose assembly removed from FAWPSS.
Repair. (Refer to Figure 4-1.)
NOTE
Repair is limited to replacement of parts found defective during inspection.
a.
Disassembly.
(1)
Cut hose clamps (1) and remove clamps from hose assembly.
(2)
Remove female coupling half (2) and male coupling half (3) from hose (4).
(3)
Remove quick disconnect plug (5) from female coupling half (2).
(4)
Remove quick disconnect cap (6) from male coupling half (3).
(5)
Remove gaskets (7) and (8) from female coupling half (2) and from quick disconnect cap (5).
b.
Cleaning.
(1) Remove all build up of dirt, oil, and debris from all mating surfaces and clamping areas.
WARNING
DO NOT breath dry cleaning solvent vapors for long periods of time or allow
solvent to come into contact with skin for an extended time. DO NOT use solvent
near open flames or excessive heat.
4-6
