BALL VALVE ASSEMBLY, 2.00 INCH, QUICK ACTING

Figure 4-2. Clamp Installation Using Clamping Tool (Appendix B, Item 2)

Figure 4-3. Ball Valve Assembly, 2.00 Inch, Quick Acting

TM-10-4320-346-12P Forward Area Water Point Supply System Model LAB 9095 NSN 4320-01-369-0369 Manual
Page Navigation
34

TM 10-4320-346-12&P 4-13. BALL VALVE ASSEMBLY, 2.00 INCH, QUICK ACTING. This Task Covers: Repair Initial Setup: Tools Required Tool Kit, General Mechanic's (Appendix B, Item 1) Wrench, Pipe (Appendix B, Item 2) Material's Required Brush, Medium Bristle (Appendix F, Item 2) Solvent, Dry Cleaning (Appendix F, Item 3) Cloth, Lint-Free (Appendix F, Item 1) Sealing Compound (Appendix F, Item 4) Gaskets (Appendix I, Item 1) Equipment Condition Assembly removed from FAWPSS installation. Repair. (Refer to Figure 4-3.) NOTE Repair is limited to replacement of parts found defective during inspection. a. Disassembly. (1) Remove quick disconnect cap (1) and gasket (2) from male coupling half (3). (2) Remove quick disconnect plug (4) and gasket (5) from female coupling half (6). (3) Remove male coupling half (3) and female coupling half (6) from ball valve assembly (7). b. Clean. (1) Remove all build up of dirt, oil, and debris from all mating surfaces and clamping areas. WARNING DO NOT breath dry cleaning solvent vapors for long periods of time or allow solvent to come into contact with skin for an extended time. DO NOT use solvent near open flames or excessive heat. (2) Clean all metallic parts with a clean soft cloth (Appendix F, Item 1) or a medium bristle brush (Appendix F, Item 2), and cleaning solvent (Appendix F, Item 3). (3) Allow parts to dry. 4-10

Privacy Statement
Press Release
Contact