TM 10-4320-346-12&P
4-15. NOZZLE STAND ASSEMBLY.
This Task Covers:
Repair
Initial Setup:
Tools Required
Tool Kit, General Mechanic’s (Appendix B, Item 1)
Materials Required
Brush, Medium Bristle (Appendix F, Item 2)
Solvent, Dry Cleaning (Appendix F, Item 3)
Cloth, Lint-Free (Appendix F, Item 1)
Cotter Pin (Appendix I, Item 3)
Equipment Condition
Assembly removed from FAWPSS installation.
Repair. (Refer to Figure 4-5.)
N O T E
Repair is limited to replacement of parts found defective during inspection.
a.
Disassembly
(1)
Remove three s-hooks (1) and three chains (2) from two pivot legs (3) and clevis leg (4).
(2)
Remove two straight pins (5) and two cotter pins (6).
(3)
Remove two pivot legs (3) from clevis leg (4).
b. Clean.
(1)
Remove all build up of dirt, oil, and debris from all mating surfaces.
W A R N I N G
DO NOT breathe dry cleaning solvent vapors for long periods of time or allow solvent
to come into contact with skin for an extended time. DO NOT use solvent near open
flames or excessive heat.
(2)
Clean all metallic parts with a clean soft cloth (Appendix F, Item 1) or a medium bristle brush
(Appendix E Item 2). and cleaning solvent (Appendix F, Item 3).
(3) Allow parts to dry.
4-14
