TM 10-4320-346-12&P4-14. NOZZLE ASSEMBLIES.This Task Covers:RepairInitial Setup:ToolsRequiredTool Kit. General Mechanic’s (Appendix B, Item 1)Wrench, Pipe (Appendix B. Item 2)MaterialsRequiredBrush, Medium Bristle (Appendix F, Item 2)Solvent, Dry Cleaning (Appendix F, Item 3)Cloth. Lint-Free (Appendix F, Item I)Sealing Compound (Appendix F, Item 4)Gasket (Appendix I. Item 2)EquipmentConditionAssembly removed from FAWPSS installation.Repair. (Refer to Figure 4-4.)NOTERepair is limited to replacement of parts found defective during, inspection.a. Disassembly.(1)Remove dust plug (10) and retaining ring ( 11) from reducer (2).(2)Remove gasket ( 1) from reducer (2).(3)Remove reducer (2) and swivel (3) from nozzle assembly (4).(4)Remove dust cap (5). cap links (6). chain (7). compression spring (8), and draw bars (9)or for Mode1 # JGB-FAWPSS-432034612P tension spring (12) from nozzle (4).b. Clean.(1)Remove all build up of dirt. oil. and debris from all mating surfaces and clamping areas.WARNINGDO NOT breathe dry cleaning solvent vapors for long periods of time or allow solventto come into contact with skin for an extended time. DO NOT use solvent near openflames or excessive heat.(2)Clean all metallic parts with a clean soft cloth (Appendix F, Item 1) or a medium bristle brush(Appendix F, Item 2). and cleaning solvent (Appendix F. Item 3).(3) Allow parts to dry.4-12Change 2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
