TM 10-4610-243-13
2-17. OPERATION IN EXTREME HEAT. - cont.
(8)
Monitor water supply for excessive bacterial and algae growth. Adjust output of hypochlorination units as
directed by medical personnel. Refer to the applicable TM.
2-18. OPERATIONS IN DUSTY OR SANDY AREAS.
Observe the following precautions when operating the water system in dusty or sandy areas:
(1)
Keep dust caps in place on fittings and couplings until ready for use.
(2)
Carefully inspect coupling gaskets before connecting fittings. Remove all dirt, sand and debris before
making connections.
(3)
Refer to the applicable TM for operating the 350 GPM pump in dusty or sandy areas.
(4)
Refer to the applicable TM for operating the 125 GPM pump in dusty or sandy areas.
(5)
Refer to the applicable TM for operating the hypochlorination unit in dusty or sandy areas.
(6)
Refer to the applicable TM for operating the water tanks under in dusty or sandy areas.
(7)
Following operation in dusty or sandy areas, rinse all components with clean, fresh water to remove
sand, dust and grit. Direct special attention to quick disconnect coupling gaskets and locking arms.
2-19. OPERATION IN SALT WATER AREAS.
Operation in salt water areas accelerates corrosion on bare metal surfaces. Observe the following precautions when
operating the water system this environment.
(1)
Carefully inspect water system components during installation. If bare metal is found, notify unit
maintenance to preserve or paint the metal as required.
(2)
Following operation in salt water areas, rinse components with clean fresh water to remove salt spray
and/or deposits.
(3)
Refer to the applicable TM for operation of the 350 gpm pump in salt water areas.
(4)
Refer to the applicable TM for operation of the 125 gpm pump in salt water areas.
(5)
Refer to the applicable TM for operation of the hypochlorination unit in salt water areas.
2-95
