TM 10-4610-243-132-10. ASSEMBLY AND PREPARATION FOR USE - cont.i.Assemble125GPMPumpAssemblyConnectionKit(WaterSource).Refer to figure 2-16.WARNINGTo prevent contamination of drinking water, make sure protective capsand plugs are installed when components are not in use. Do not removecaps and plugs from components until couplings are ready to beconnected.NOTESInstall all gate valves with hand wheel in upright position and valve fully closed.Suction hoses are noncollapsible and discharge hoses are collapsible.With exception of two adapters, all couplings in this kit are 2-inch diameter.(1)Connect adapter- (4-inch female x 2-inch male) (2) to tee (1) from 350 gpm pumpconnection kit.(2)Connect 20 foot suction hose (3) to adapter (2).(3)Connect 2-inch gate valve (4) to 20 foot suction hose (3).(4)Connect 20 foot suction hose (5) to 2-inch gate valve (4).(5)Assemble and prepare 125 gpm pump (6) for use. Refer to the applicable TM.(5)Position 125 gpm pump (6) in water system.(7)Connect end of 20 foot suction hose (5) to female (suction) coupling (7) on pump (6).(8)Connect 20 foot discharge hose (9) to male (discharge) coupling (8) on 125 gpm pump(6).(9)Connect check valve (10) to 20 foot discharge hose (9).(10)Connect 2-inch gate valve (11) to check valve (10).(11)Connect 20 foot discharge hose (12) to 2-inch gate valve (11).(12)Connect adapter (4-inch male x 2-inch female) (13) to tee (14) from 350 gpm pumpconnection kit.(13)Connect end of 20 foot discharge hose (12) to adapter (13).2-46
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
