TM 10-4610-243-13
2-10. ASSEMBLY AND PREPARATPION FOR USE - cont.
(17)
Connect water meter (16) to 20 foot discharge hose (15).
(18)
Connect tee (17) to water meter (16).
(19)
Connect adapter (4-inch male x 4-inch male) (18) to 10 foot discharge hose (19) (part of dual tank
connection kit no. 4)
(20)
Connect 10 foot discharge hose (20) (part of dual tank connection kit no 5) to adapter (18).
k.
Assemble 125 Gpm Pump Connection Kit (Distribution Point). Refer to figure 2-18.
WARNING
To prevent contamination of drinking water, make sure protective caps and plugs are
installed when components are not in use. Do not remove caps and plugs from
components until couplings are ready to be connected.
NOTES
Install all gate valves with hand wheel in upright position and valve fully closed.
Suction hoses are noncollapsible and discharge hoses are collapsible.
With exception of two adapters, all couplings in this kit are 2-inch diameter.
(1)
Connect adapter (4-inch female x 2-inch male) (2) to tee (1) (part of 350 gpm pump connection
kit).
(2)
Connect 20 foot suction hose (3) to adapter (2).
(3)
Connect 2-inch gate valve (4) to 20 foot suction hose (3).
(4)
Connect 20 foot suction hose (5) to 2-inch gate valve (4).
(5)
Assemble, prepare for use, and position 125 gpm pump (6) in water system. Refer to the
applicable TM.
(6)
Connect end of 20 foot suction hose (5) to female (suction) coupling (7) on 125 gpm pump (6).
(7)
Connect 20 foot discharge hose (9) to male (discharge) coupling (8) on 125 gpm pump (6). Refer
to the applicable TM.
(8)
Connect check valve (10) to 20 foot discharge hose (9).
(9)
Connect 2-inch gate valve (11) to check valve (10).
(10)
Connect 20 foot discharge hose (12) to 2-inch gate valve (11).
(11)
Connect adapter (4-inch male x 2-inch female) (13) to tee (14) (part of 350 gpm pump connection
kit).
2-50
