TM 10-4610-243-132-10. ASSEMBLY AND PREPARATION FOR USE - cont.m.AssemblehoseNozzleConnectionKits. Refer to figure 2-20.WARNINGTo prevent contamination of drinking water, make sure protective caps andplugs are installed when components are not in use. Do not remove caps andplugs from components until couplings are ready to be connected.NOTEInstall all gate valves with hand wheel in upright position and valve fully closed.Four 2-inch hose nozzle connection kits are used in the water system Connection kit no. 1 is shown, kitno 2, 3, and 4 are similar.(1)Connect 4 inch x 20 foot discharge hose (2) to tee assembly (1) (2-inch hose connection kit).(2)Connect 4 inch x 20 foot discharge hose (3) to 4 inch x 20 foot discharge hose (2).(3)Connect tee (4) to 4 inch x 20 foot discharge hose (3).(4)Connect adapter (4 inch female x 2-inch male) (5) to tee (4).(5)Connect 2-inch gate valve (6) to adapter (5).(6)Connect 2 inch x 20 foot discharge hose (7) to gate valve (6).(7)Connect adapter (2 inch female x 1-½ inch male) (8) to 2 inch x 20 foot discharge hose (7).(8)Connect 1-½ inch x 25 foot discharge hose (9) to adapter (8).(9)Connect distribution nozzle (10) to 1-½ inch x 25 foot discharge hose (9).(10)Unfold nozzle stand assembly (11) and attach distribution nozzle (10) to bracket on stand.(11)Repeat steps I through 10 for connection Kits 2, 3, and 4.2-54
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
