ASSEMBLY AND PREPARATION FOR USE - cont

ASSEMBLY AND PREPARATION FOR USE - cont - TM-10-4610-243-13_76

ASSEMBLY AND PREPARATION FOR USE - cont - TM-10-4610-243-13_78

TM-10-4610-243-13 800K Water Storage and Distribution System Model WSDS810 NSN: 4610-01-360-1581 Manual
Page Navigation
68

TM 10-4610-243-13 2-10. ASSEMBLY AND PREPARATION FOR USE - cont. o. Assemble Hose and Nozzle Kits. Refer to figure 2-22. WARNING To prevent contamination of drinking water, make sure protective caps and plugs are installed when components are not in use. Do not remove caps and plugs from components until couplings are ready to be connected. NOTE A 2 inch female x 1-½ male adapter is supplied with each hose and nozzle kit for connecting the kits directly to a 2 inch discharge hose. These adapters will not be used in this assembly procedure. Your operating conditions may require use of the adapters Three hose and nozzle kits are used in the water system. Kit no 1 is shown, kit no. 2 and 3 are similar. (1) Connect adapter (1-½ inch female x 1 inch male) (2) to 1-½ inch x 25 foot discharge hose (1) (from bag filler connection kit). (2) Connect two 1 inch x 10 foot discharge hoses (3 and 4) to adapter (2). (3) Connect regulator (5) to 1 inch x 10 foot discharge hose (4). Make sure regulator is positioned with wooden base down on ground. (4) Connect two 1 inch x 10 foot discharge hoses (6 and 7) regulator (5). (5) Connect distribution nozzle (8) to 1 inch x 10 foot discharge hose (7). (6) Unfold nozzle stand assembly (9) and attach distribution nozzle (8) to bracket on stand. (7) Repeat steps (1) through (6) for kit no 2 and no 3. 2-58

Privacy Statement
Press Release
Contact