TM10-5430-229-13&P
Section III. OPERATION UNDER USUAL CONDITIONS
2-6. ASSEMBLY AND PREPARATION FOR USE. This paragraph shows how to assemble the WTSC and prepare it for
use. The steps provided and the illustrations shown are for a typical set up of the WTSC. Always be sure that you follow
your local operating procedures first if there is a conflict The WTSC is ready for use when it has been removed from its
shipping and packing material. In the event that the WTSC has been sent to you in an unassembled state, use the fol-
lowing procedures to assemble the WTSC for use (Refer to Figure 2-3.)
WARNING
Serious injury could occur if heavy equipment is moved/lifted without sufficient person-
nel to do the job. Wear safety shoes, gloves, and other suitable protective clothing. Do
not try to lift more than 50 pounds by yourself.
a.
Place the skid assembly (1) into position on a level surface. Contact unit maintenance for help in positioning
the WTSC.
NOTE
Before installing side panels, be sure that all holes in the top surface of the skid are
free from dirt and debris.
Be sure that all end panel and side panel gasket material is undamaged before in-
stalling panels onto skid.
b.
Install each of the two side panel assemblies (2) onto the skid assembly (1). Make sure that the locking pins (3)
on the bottoms of the channel assemblies (4) on the side panel assemblies are properly aligned in the channel mounting
holes of the skid assembly.
c.
Lift up the locking pin latches (5) on the skid assembly (1) and move them either to the left or to the right as re-
quired to insert the ends of the skid assembly locking pins into the locking pins (3) on the channel assemblies (4) which
are equipped with locking pins.
NOTE
When installing the end panel assemblies, be sure that the lettering on the end panel is
right side up and that the gasket material on each end panel is positioned to rest on the
top of the skid assembly.
d.
Place each of the two end panel assemblies (6) into position on each end of the skid assembly (1). Rotate
each of the four turnlock handles (7) 90° counterclockwise to latch the end panels into each of the side panels (2).
e.
Place the top cover (8) onto the top of the side panels (2) and the end panels (6). Be sure that the strike
catches on the top cover align with the latching devices (9) on the side panel channel assemblies (4) that have latches.
f.
Lift the handles of the channel assembly (4) latching devices (9) to engage the bolt of the latching devices with
the strike catches on the top cover (8). Pull the handles of the latching devices over and down until the handles are ver-
tical and the latch snaps into place securing the top cover to the side panel assemblies (2).
2-10
