TM10-5430-229-13&P
4-11.
DOCUMENT POUCH REPLACEMENT.
This Task Covers:
a. Removal
b. Cleaning
c. Inspection
d. Installation
Initial Setup:
Tools Required
None
Material's Required
Cloth, Lint-Free (Appendix F, Item 1)
Brush, Medium Bristle (Appendix F, Item 2)
Solvent, Dry Cleaning (Appendix F, Item 3)
Soap (Appendix F, Item 4)
Equipment Condition
Not applicable.
a. Removal. (Refer to Figure 4-2.) Remove document pouch (1) from side panel assembly (2) by unsnapping
pouch from snap fasteners on side panel assembly.
b. Cleaning.
(1) Remove all build up of dirt, oil, and debris from all metal surfaces.
WARNING
Serious injury can result in breathing fumes of dry cleaning solvent A-A-711. Serious injury or
death can result from explosion of fumes from solvent. When using this solvent:
Clean parts in a well ventilated area.
Avoid inhalation of solvent fumes and prolonged exposure of
skin to cleaning solvent. Wash exposed skin thoroughly.
Do not use near open flame or excessive heat. Flash point of
solvent is 100° F to 138 F (38 C to 59° C).
Wear eye protection when blowing solvent from parts. Air pres-
sure should not exceed 30 psig (2.1 kg/cm2).
(2) Clean all metallic parts with a clean soft cloth or a medium bristle brush and cleaning solvent.
(3) Clean other non-metallic document pouch material with a solution of soap and water.
(4) Allow parts to dry.
4-6
