TM 10-5430-243-12&P
0026 00
0026 00-1
UNIT MAINTENANCE
TANK, FABRIC, COLLAPSIBLE, WATER STORAGE,
20,000 AND 50,000 GALLONS
FILLER/DISCHARGE ASSEMBLY (GTA CONTAINER MODEL)
REMOVAL, SERVICE, REPAIR AND INSTALLATION
INITIAL SETUP
Tools
Equipment Condition
Tool Kit, General Mechanics
Filler/Discharge hose assembly removed
(Item 1, WP 0033 00)
(WP 0023 00)
Torque Wrench, (ft-lb)
(Item 3, WP 0033 00) Mandatory Replacement Parts
Gasket
Materials/Parts
(Item 1, WP 0041 00)
Detergent, General Purpose
Gasket
(Item 2, WP 0039 00) (Item 11, WP 0041 00)
Rag, Wiping
Gasket
(Item 4, WP 0039 00) (Item 12, WP 0041 00)
Silicone Compound
Lockwasher
(Item 6, WP 0039 00)
(Item 6, WP 0041 00)
Tape, Anti-seize
O-ring Seal
(Item 7, WP 0039 00)
(Item 10, WP 0041 00)
DISASSEMBLY
CAUTION
Be sure to take off the closure plate before removing the flanged adapter. The
flanged adapter is bolted to the closure plate. If the flanged adapter is removed
first, the hex head nuts will fall into the tank.
NOTE
The filler/discharge fitting on the discharge end requires a female/male elbow. The
filler/discharge fitting on the fill end requires a female/female elbow.
1. Remove 4-inch elbow (1) by pulling outward on cam-lever arms (2), and lifting elbow (1) from flanged
adapter (3).
2. Remove and discard elbow gasket (4) from inside elbow (1).
3. Remove twenty screws (5) and washers (6) from closure plate (7). Lift closure plate (7) from tank
fitting (8).
4. Remove and discard o-ring (9) from the packing groove located in tank fitting (8).
5. Remove eight nuts (10), lockwashers (11), screws (12), and gaskets (13) from flanged adapter (3),
and flanged adapter gasket (14). Discard lockwashers (11), gaskets (13), and gasket (14).
6. Remove and discard gasket (15) from inside dust cap (16).
