TM 10-5430-243-12&P 0027 00 0027 00-3/4 blank Change 1 REPAIR Repair is limited to replacement of damaged components. ASSEMBLY1. Install new gasket (16) into dust cap (17). 2. Install new elbow gasket (4) into elbow (1). 3. Place suction stub (14) on a hard, flat surface with the eight bolt holes positioned up. 4. Position new gaskets (13) over each bolt hole in suction stub (14). 5. Position closure plate (7) on top of new gaskets (13), and align holes. 6. Position new flanged adapter gasket (15) on closure plate (7), and align the holes. 7. Position flanged adapter (3) on gasket (15), and align the holes. 8. Install screws (12) and new gaskets (13) (if required) through the holes in flanged adapter (3), and thread screws (12) through until the ends protrude through suction stub (14). NOTE MPC Model Tanks use an additional eight gaskets on the screws for mounting the suction stub. 9. Assemble new gaskets (13), new lockwashers (11), and nuts (10) to screws (12). Torque the fastening hardware to 15 ft-lb (20.34 Nm) for Reliance Models, or 16 ft-lb (21.70 Nm) for MPC Models. 10. Lubricate new o-ring seal (9) with silicone compound. Position o-ring (9) into the packing groove. 11. Install closure plate (7) and attached components through the opening in the tank, until closure plate (7) contacts the tank fitting (8). NOTE If the tank is lying completely flat, lift the tank to the closure plate to begin threading the screws through the tank fitting. 12. Assemble twenty washers (6) onto screws (5). Install screws (5) through closure plate (7) and tank fitting (8). 13. Torque fastening screws (5) to 15 ft-lb (20.34 Nm) for Reliance Models, or 16 ft-lb (21.70 Nm) for MPC Models. 14. Position elbow (1) on flanged adapter (3), and push cam-lever arms (2) inward, locking elbow (1) to flanged adapter (3). END OF WORK PACKAGE
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
