TM 10-8110-202-13&Ph.When drum is completely filled (4.0-5.0 psi working pressure), turn handwheel (2) all the way clockwise to closecoupler valve (1), thus shutting off water supply to the drum.i.Unlock and remove coupler valve (1) from adapter assembly (4). Leave filler hose attached to the coupler valveand use this coupler valve to fill the other drums.j.Install two coupler valves (1) onto filled drum.k.Repeat steps c. through j. for each drum to be filled.l.When last drum has been filled, shut off valve at drinking water source and disconnect filler hose (6) from thecoupler valve (1) that was used to fill drums. Leave coupler valve installed on drum. Install another coupler valveonto the other end of drum.CAUTIONEach drum comes with two coupler valves. After filling the drum leave the two coupler valvesinstalled on the drum except during transportation. Remove the two coupler valves from the drumwhen it is being transported to prevent damage to the valves. During transport, the coupler valvesmust remain with the drum so they are not lot. Be sure coupler valves are protected from dirt andother foreign matter when not installed on the drum.2-4.DISPENSING DRINKING WATER FROM DRUMCAUTIONDo not overload transport vehicle with filled drums. Each model GTAIND500-S/01 filled drumweighs 4344 pounds (1974.5 kg). Each model RD-610 filled drum weighs 4645 pounds (2107 kg).Each Model M43699-02 filled drum weighs 4432 pounds (2010 kg).Check transport vehicle’s weightlimits before loading with drums.a.Roll, tow, or otherwise transport filled drum to place of use.b.Select a dispensing site that is as level and dirm as possible.c.Perform daily Preventive Maintenance Checks and Services (PMCS). See Table 2-1.d.Uncover one or both adapter assemblies (4) at either end of drum by removing dust caps (3).e.Turn handwheel (2) all the way clockwise to close coupler valve (1).Change 5 2-11
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
