TM 10-8110-202-13 & P
ASSEMBLY/REPLACEMENT:
1.
2.
3.
4.
5.
6.
7.
8.
All coupler valve parts must be cleaned with a mild non-
toxic detergent and assembled on a clean surface. Re-
member that the coupler valve will be used to dispense
drinking water.
A dirty or contaminated coupler valve
part could cause sickness or death to personnel drinking
water from the drum.
Clean all coupler valve parts with a mild non-toxic detergent
Install valve stem (5) into valve body (1).
Only new gaskets (2) and
sembly procedures.
Insert a new packing (8) into valve body
(1) over valve stem (5).
Install packing gland (7) into valve body
(1) over valve stem (5).
Install packing nut (6) onto valve body
(1) and tighten using a 1-1/8 inch open
end wrench.
Install handwheel (4) onto valve stem (5).
Install nut (6) onto valve stem (5) and
tighten.
Install two new gaskets (2) into valve
body (1).
and stiff-bristle cleaning brush.
packing (8) may be used in as-
5-14
