TM 10-8110-202-13 & Pf. Position and center patch 2 over patch 1 with the cement side down.g. Roll and stitch patch 2 thoroughly using a roller and stitcher.NOTEExterior repair is now complete. Proceed to interior repairinstructions, following.INTERIOR REPAIR:1.2.3.4.5.6.7.8.Remove all dirt from area around hole to be repaired.Wash with mild non-toxic detergent and water.Using a buffing tool, thoroughly buff an area 5 inches in all directions from the edge of the hole.Remove buffing dust and wash area with non-toxic detergent and water.NOTEUnder normal atmospheric conditions the cement will dryin 1 to 3 minutes. Excessive humidity will require longerdrying time. Do not mix applicator brushes with differentcements.Apply one coat of PT-659 cement to entire buffed and cleaned area around hole. Allow cementto dry.Apply a second coat of PT-659 cement to buffed and cleaned area.Cut out two patches as follows:a. Patch 1. Cut a patch from PS-692 patch material that is 3 inches larger than the hole inall directions.b. Patch 2. Cut a patch from PS-692 patch material that is 1/2 inch larger than patch 1 inall directions.Apply the two patches over interior of hole as follows:a.b.c.d.e.Apply one coat of PT-589 cement to one side of patch 1 and allow to dry.Position and center patch 1 over hole with the cement side down.Roll and stitch patch 1 thoroughly using a roller and stitcher.Apply one coat of PT-589 cement to top side of patch 1 and allow to dry.Apply one coat of PT-589 cement to one side of patch 2 and allow to dry.5 - 3 2Change 1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
