TM 5-3820-256-10
CAUTION
Do not torque the crane too tightly to the boom stand.
(6)
Tighten the crane winch enough to secure the crane to the boom stand.
(7)
Replace the remote control pendant (1) in the storage box (2); close and latch the box.
(8)
From inside the truck cab, turn off the remote control power switch and disengage the PTO/hydraulic
system.
2-12.
Welder/Generator
a. Assembly and Preparation for Use.
(1)
Initial Setup. Set up the rig tender as level as possible (within 5 degrees from level); keep unit level during
operation.
WARNING
Battery acid can burn your eyes and skin, and can destroy clothing and other material. Wear correct eye
and body protection when working with batteries. Failure to follow this warning may result in injury to
personnel.
CAUTION
Abnormal voltage can cause damage to the engine electrical components. Do not operate the engine
without the battery connected. Do not disconnect the battery while the engine is running.
(2) Power Connections. First, connect the positive (+) battery cable to the positive (+) battery terminal. Then
connect the negative (-) battery cable to the negative (-) battery terminal.
WARNING
Engine fuel can cause fire or explosion. Do not spill any fuel. Do not refuel near sparks or open flame.
Do not smoke while refueling. Do not fill tank to top; allow 3/4 inch from fuel level to top of tank.
CAUTION
Do not use gasoline to fuel the engine, gasoline will damage engine. Failure to follow this caution will
result in engine damage.
2-61
