TM 5-3820-256-10
(b)
Connect weld cables to appropriate weld output receptacles.
1
To obtain DC straight polarity weld output, connect work cable jack plug to positive (+) receptacle.
Connect electrode cable jack plug to negative (-) receptacle.
2
To obtain DC reverse polarity weld output, connect work cable jack plug to negative (-)
receptacle. Connect electrode cable jack plug to positive (+) receptable.
3
To obtain AC weld output, connect work cable jack plug to WORK receptacle. Connect electrode
cable jack plug to ELECTRODE receptacle.
b. Initial Adjustments, Daily Checks, and Self-Tests.
(1)
Initial Adjustments.
WARNING
Engine fuel can cause fire or explosion. Do not spill any fuel. Do not refuel near sparks or open flame.
Do not smoke while refueling. Do not fill tank to top; allow 3/4 inch from fuel level to top of tank. Failure
to follow this warning may cause death or injury to personnel.
(a)
Fill fuel tank with fresh diesel fuel before starting engine for first time.
(b)
Examine inside of fuel cap. Open valve if cap is equipped with a valve.
(c)
Check oil level using oil level dipstick. Add oil, if necessary, until oil level is at the MAX mark on the
dipstick.
(d)
Check battery terminal connections. Tighten connections if necessary.
(2)
Daily Checks.
WARNING
Engine fuel can cause fire or explosion. Do not spill any fuel. Do not refuel near sparks or open flame.
Do not smoke while refueling. Do not fill tank to top; allow 3/4 inch from fuel level to top of tank. Failure
to follow this warning may cause death or injury to personnel.
(a)
Check fuel tank. Fill tank if tank is not full of fuel.
(b)
Check oil level using oil dipstick. Add oil, if necessary, until oil level is at MAX mark on the dipstick.
2-63
