DIFFERENTIAL CARRIER

TORQUE SPECIFICATIONS - TM-5-3820-256-24-4_56

TM-5-3820-256-24-4 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
19

VII. DIFFERENTIAL CARRIER A. Removal of Differential Carrier from Axle All service of the differential carrier assembly requires removal of the assembly from the axle housing. 1. Remove the drain plugs and drain lubricant from axle housing. 2. Disconnect propeller shaft at pinion yoke. 3. Refer to Section IV-F, and remove both inner axle shafts. 4. Attach differential carrier to a suitable roller jack. (See fig. 42). 5. Remove capscrews and nuts holding differential carrier to axle housing. 6. Roll differential carrier away from the axle. (See fig. 43). B. Installation of Differential Carrier to Axle 1. Refer to the Differential Carrier Service Manual for detailed service procedures. 2. Apply a bead of liquid sealant to the differential mounting face. See Service Bulletin 738 407, page 22. Apply in the same manner as shown for the axle flanges, a bead and a ring around each bolt hole. 3. Position the differential carrier in the axle housing with a suitable roller jack, (See fig. 43), picking up two locating studs. 4. Install differential carrier capscrews and stud nuts. Tighten to the correct torque. Fig. 43 5. Connect the propeller shaft. 6. Assemble the Steerable Drive Ends as outlined in Section VI. 7. Install the drain plug and fill the axle to the bottom edge of the level hole with the appropriate lubricant. 8. Install the level plug. Fig. 42 Fig. 43 -20-

Privacy Statement
Press Release
Contact