SERVICE MANUAL
WATER PUMP, THERMOSTAT & IDLER PULLEYS
Section 9
3.
Pull off the impeller (1, Fig. 5) using the two 1/2
inch holes provided as shown.
Figure 5 - Removing Impeller
1. Impeller
2. Puller
NOTE: If the impeller is equipped with 1/4 inch
holes, enlarge them to 1/2 inch to accept a small
puller (2, Fig. 5).
4.
Support the bearing housing (1, Fig. 6) as shown
and press the shaft and bearing assembly out of
the bearing housing.
5.
Pry out the ceramic seat and boot (1, Fig. 7)
from the impeller and discard it, along with the
water pump seal (2) as shown.
6.
Drive out the metal part of the water pump seal
(5, Fig. 8) from the front of the housing. Discard.
Figure 6. - Removing Shaft and Bearing Assembly
1. Bearing housing
Figure 7. - Water Pump Seal
1. Seat and boot
2. Seal
CGES-185-3
PRINTED IN UNITED STATES OF AMERICA
Page 5
