SERVICE MANUALWATER PUMP, THERMOSTAT & IDLER PULLEYSSection 94.Remove the spacer/wear sleeve (2, Fig.19), then discard the front bearing greaseseal (1) as shown.Figure 19. - Front Grease Seal and Wear SleeveRemoval1. Front bearing grease seal2. Spacer/wear sleeve5.Remove the retainer ring (1, Fig. 20) usinga ring expander (2) as shown.Figure 20. - Retaining Ring Removal1. Retaining ring2. Ring expander tool6.Press out the shaft from the rear of the housing,as shown in Fig. 21. The bearings and spacerswill come out with the shaft (1, Fig. 21). Pressbearings from shaft.Figure 21. - Press Out Shaft and Bearings1. Bearings, spacers and shaft2. Steel rod7.Drive out the metal part of the water pump seal(4, Fig. 18) from the front of the housing, andrear bearing grease seal (5) from the rear.Discard both parts.CGES-185-3PRINTED IN UNITED STATES OF AMERICAPage 11
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
