WATER PUMP, THERMOSTAT & IDLER PULLEYS - CONT

WATER PUMP, THERMOSTAT & IDLER PULLEYS - CONT - TM-5-3820-256-24-5_340

WATER PUMP, THERMOSTAT & IDLER PULLEYS - CONT - TM-5-3820-256-24-5_342

TM-5-3820-256-24-5 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
310

SERVICE MANUAL WATER PUMP, THERMOSTAT & IDLER PULLEYS Section 9 CG-5967 Figure 44. - Tool Fabrication Dimensions for Holding Shaft 14. Apply 102 N•m (75 Ibf-ft) torque to nut and shaft as shown in Figure 45. Figure 45. - Torquing Nut 1. Tool 15. Install plug (1, Fig. 39), into bracket. 16. Install idler onto engine. 17. Install belts. Refer to the Operator's Manual for belt adjusting procedures. PROCEDURE FOR AIR COMPRESSOR IDLER PULLEY. DISASSEMBLY Disassemble the Air Compressor Idler Pulley (New Style) as follows: (See Fig. 46) 1. With suitable tool, press bearing (3, Fig. 46) out from idler bracket (5). 2. Remove front retaining ring (1) from pulley (2). 3. Remove rear retaining ring (4). 4. Press bearing (3) from pulley (2). Figure 46. - New Style 1. Ring, front retaining 2. Pulley, air compressor idler 3. Bearing (with shaft), idler 4. Ring, rear retaining 5. Bracket, idler support 6. Bolt, 1/2 - 13 x 3/4 7. Washer, 1/2 hardened CGES-185-3 PRINTED IN UNITED STATES OF AMERICA Page 26

Privacy Statement
Press Release
Contact