WATER PUMP, THERMOSTAT & IDLER PULLEYS - CONT

WATER PUMP, THERMOSTAT & IDLER PULLEYS - CONT - TM-5-3820-256-24-5_335

WATER PUMP, THERMOSTAT & IDLER PULLEYS - CONT - TM-5-3820-256-24-5_337

TM-5-3820-256-24-5 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
305

SERVICE MANUAL WATER PUMP, THERMOSTAT & IDLER PULLEYS Section 9 PROCEDURE FOR FAN IDLER PULLEY WITH FRONT BALL BEARING AND REAR ROLLER BEARING: DISASSEMBLY Disassemble the Fan Idler Pulley with Front Ball Bearing and Rear Roller Bearing as follows: 1. Remove the plug (1, Fig. 31). 2. Remove the nut (2) and washer (3). 3. Using a suitable puller, remove the pulley (4). 4. With a snap ring pliers, remove the outer snap ring (5). Figure 31. - Fan Idler Assembly with Front Ball Bearing and Rear Roller Bearing 1. Plug 2. Nut 3. Washer 4. Pulley 5. Snap ring (outer) 6. Snap ring (inner) 5. Tap out the shaft and ball bearing assembly from the rear of the bracket. Use a brass drift, as shown in Figure 32. 6. Remove ball bearing (1, Fig. 33) from the shaft (2) with a suitable puller (3) as shown. Figure 32. - Removing Shaft with Brass Drift CG-5823 Figure 33. - Removing Ball Bearings 1. Ball bearing 2. Shaft 3. Puller CGES-185-3 PRINTED IN UNITED STATES OF AMERICA Page 21

Privacy Statement
Press Release
Contact