WATER PUMP, THERMOSTAT & IDLER PULLEYS - CONT

WATER PUMP, THERMOSTAT & IDLER PULLEYS - CONT - TM-5-3820-256-24-5_334

WATER PUMP, THERMOSTAT & IDLER PULLEYS - CONT - TM-5-3820-256-24-5_336

TM-5-3820-256-24-5 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
304

SERVICE MANUAL WATER PUMP, THERMOSTAT & IDLER PULLEYS Section 9 7. Wipe wear sleeve (10) with grease. 8. Prepack rear bearing cone (14) with I.H. 251H- EP grease and install onto shaft (11). 9. Install spacer (15) onto shaft. 10. Install pulley (13) onto the shaft. Be careful not to damage oil seal (9). 11. Prepack front bearing cone (14) and install onto shaft. 12. Install washer (4) and nut (3). Torque nut to 102 N•m (75 lbf-ft) while holding the shaft securely. 13. Fill the cavity of the pulley with I.H. 251H-EP grease. 14. Using a new gasket (5), install and secure cover (2). 15. Install assembly on the engine. Refer to the Operator's Manual for belt adjusting procedures. Figure 30. - Idler Pulley Assembly 1. Screw 9. Oil seal 2. Cover 10. Wear sleeve 3. Nut 11. Pulley shaft 4. Washer 12. Bracket 5. Gasket 13. Pulley 6. Bearing cup 14. Bearing cones 7. Spacer 15. Spacer 8. Bearing cup CGES-185-3 PRINTED IN UNITED STATES OF AMERICA Page 20

Privacy Statement
Press Release
Contact