ROBERT BOSCH MODEL MW INJECTION PUMP - CONT

ROBERT BOSCH MODEL MW INJECTION PUMP - CONT - TM-5-3820-256-24-5_367

ROBERT BOSCH MODEL MW INJECTION PUMP - CONT - TM-5-3820-256-24-5_369

TM-5-3820-256-24-5 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
337

SERVICE MANUAL ROBERT BOSCH MODEL MW INJECTION PUMP Section 11 Figure 35. - Outer Throttle Control Lever REPLACING OR REPAIRING ELECTRIC SHUTOFF SOLENOID, MOUNTING BRACKET, ADJUSTING ROD AND ROD END AND ADJUSTING LINKAGE (FIGURE 36) All Cargostar vehicles are equipped with electric shutoffs. If a vehicle was originally equipped with cable shutoff, electric shutoff can be field installed. Figure 36. Follow these procedures step by step to prevent solenoid burnout or internal damage to injection pump. 1. Remove solenoid plunger from solenoid and cap opening. 2. Assemble solenoid to bracket and tighten bolts. 3. Assemble bracket to engine at front cover and crankcase mounting locations. 4. Assemble rod end to shutoff lever and tighten bolt. DO NOT connect rod end to adjusting rod at this time. 5. Thread adjusting rod to solenoid plunger until bottomed, then tighten locknut. 6. Reinstall plunger into solenoid, depress plunger to bottom, energize solenoid using a 12 volt D.C. power source with 8 ampere "slow blow" fuse protection (Figure 37). Be sure that positive lead is connected to positive terminal, negative to negative. When solenoid is mounted to engine, the positive terminal will be closest to engine water pump and the negative terminal will be between the positive terminal and the unused auxiliary terminal. The auxiliary is closest to flywheel housing. Solenoid is to be energized through step 7. Figure 37. CGES-185-3 PRINTED IN UNITED STATES OF AMERICA Page 24

Privacy Statement
Press Release
Contact