G. Front Output Shaft Removal
- Refer to Page PM2 and PM3
1.
Remove the seal carrier (Item 5) from the front of the
case and the cap (Item 17) from the rear of the case.
2.
Drive the shaft from the rear of the case until the
front bearing (Item 8) is clear of the housing. Use a
bearing puller or blocking between the bearing and
the case to remove the bearing from the shaft.
3.
The shaft and gear assembly may then be removed
as shown in Fig. 7.
4.
Remove the shaft from the gear in an arbor press.
Fig. 7
-14-
