Figure 24. - Control Assembly and Cables

Figure 22. - Hot Water Flow Control Valve Connections

TM-5-3820-256-24-5 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
569

S-SERIES AIR CONDITIONING - HEATER SYSTEM Figure 24. - Control Assembly and Cables 4. Disconnect instrument panel lamp socket from control assembly as follows: a. Rotate lamp socket clockwise (as viewed from rear of vehicle). b. Pull lamp socket (with bulb) from control assembly. 5. Remove control cable to control lever retaining clips. Remove control cable mounting screws and disconnect control cables from control levers. 6. Remove Control assembly. Installation 1. Connect control cables to control assembly levers as follows: b. Cable with white mounting tab to center (HTR) lever. c. Cable with black mounting tab to lower (AIR OUTLET) lever. Install control cable mounting screws and cable retaining clips. 2. Connect instrument panel lamp socket to control assembly. 3. Connect wiring harness connector to blower switch. 4. Position control assembly in instrument panel and install trim plate and mounting screws. 5. Check operation and adjustment of control cables as outlined under Control Cable Adjustment. CTS-4066A Page 16

Privacy Statement
Press Release
Contact