TM 5-3825-226-24
20. Secure three stator leads to regulator (18) with nuts
(19).
21. Attach regulator cover (17) to stator housing with
four screws (16).
22. Install washer (15) and plate (14).
23. Install bearing (13) in end frame (6).
24. Install collar (10), retainer (9), and three screws (8).
25. Install rotor (7) shaft into end frame (6).
26. Secure end frame assembly to stator housing with
four bolts (5).
27. Install fan (4), pulley (1), locknut (2), and washer
(3).
28. Position alternator in a vise or similar clamping
device.
CAUTION
Be
careful
not
to
overtighten
alternator in vise. Damage is
possible to alternator if vise is
overtightened.
29. Tighten locknut (2) to a torque of 70 to 80 lb. ft.
(95 to 109 N m).
30. The rotor normally retains magnetism to provide
voltage buildup as the rotor turns. However, after
disassembly it may be necessary to remagnetize the
rotor. Use the following procedures to magnetize the
rotor:
(1)
Install the alternator.
(2)
Remove
protective
cap
(38)
from
alternator relay terminal.
(3)
Momentarily connect a jumper lead from
the battery positive post to the relay terminal on the
alternator.
(4)
Install protective cap (38) on alternator
relay terminal.
3-11
