TM 5-3825-226-24
AIR COMPRESSOR GOVERNOR
INSTALL AIR COMPRESSOR
GOVERNOR
1. Put filters (3) in locations (1) and (2) in governor housing (4).
2. Install the plug in location (2) and the elbow in location (1) in
governor housing (4).
3. Install O-ring seals (6) on sleeve (9). Make sure the small
grommet is in position inside of sleeve (9).
4. Install spring (5), valve (10), sleeve (9), spring (7) and valve
(8) in governor housing (4).
5. Install grommet (14), spacer (17), grommet (13) on bolt (18).
Install this assembly in spring (16).
Install retainer (12), washer (15) and tighten adjustment nut (11)
over bolt (18) to the original position before it was disassembled
for correct spring tension.
6. Install the spring assembly, ring (19) and cover (20) in
governor housing (4).
7. Put governor housing (4), the spacer and two gaskets in
position on the air compressor and install bolts (22) to hold it.
8. Connect air line (21) to governor housing (4).
NOTE
For more information on the air compressor
and governor see AIR COMPRESSORS in
VEHICLE SYSTEMS.
3-13
