ASSEMBLE DELCO-REMY STARTING MOTOR

DISASSEMBLE DELCO-REMY STARTING MOTOR (cont)

ASSEMBLE DELCO-REMY STARTING MOTOR (cont)

TM-5-3825-226-24 Distributor Water Tank Type: Truck Mounted Gasoline Driven (NSN 3820-00-954-9033) Manual
Page Navigation
223

TM 5-3825-226-24 ASSEMBLE DELCO-REMY STARTING MOTOR (3T8946) 1. Install two seals (1) and lever assembly (2) on shaft (3). 2. Install shaft (3) in lever housing (4) and install retaining ring (5). 3. Position insulator (6), three insulators (7), and coil assembly (8) in armature housing (9). 4. Apply thread sealant to the threads of twelve screws (10). Install screws (10) and six pole shoes (11) in armature housing (9). 5. Install insulator bushing (12), three washers (13 and 14), nut (15), terminal (16), lockwasher (17), and nut (18) on armature housing (9). 6. Install washer (19), boot (20), retainer (21), spring (22), retainer (23), and retaining ring (24) on plunger assembly (25). 7. Install plunger assembly (25) in lever housing (4). 8. Install six brushes (26) on brush holders (27) with screws (28). 9. Install brush holders (27), plates (29, 30 and 31), insulator (32), washers (33) and plate (34) and then install screws (35) and lockwashers (36). 10. Install insulator (37) and seal (38) on plate assembly (39). 11. Install two washers (40) on terminal stud. 12. Install plate assembly (39) to frame assembly (41) with three screws (42) and lockwashers (43). 13. Apply a small amount of lubricant to washers (44 and 45) and install washers on armature (46). 3-43

Privacy Statement
Press Release
Contact