TM 5-3825-226-24
OIL FILTER BASE AND ENGINE OIL COOLER
REMOVE OIL FILTER BASE AND ENGINE OIL
COOLER
Tools Needed
A
2P8250
Strap Wrench
1
start by:
a) remove crankcase guard
NOTE:
The radiator is removed for better
photo illustration of the removal and
installation of the oil filter base and
engine oil cooler.
1.
Drain the coolant from the cooling system.
2.
Disconnect hoses (1) from the cylinder block.
3.
Remove oil filters (3) from the filter base with
tool (A).
4.
Disconnect oil pressure line (2) from the filter
base.
5.
Remove four bolts (5) and the washers to
remove oil filter base and engine oil cooler (4)
as a unit.
INSTALL OIL FILTER BASE AND ENGINE OIL
COOLER
1.
Inspect the O-ring seals in the oil filter base.
Install new seals if needed. Put oil on the seals.
2.
Put oil filter base and engine oil cooler (1) in
position on the engine. Install bolts (3) and the
washers that hold it in place.
3.
Install two oil filters (4) and connect oil pressure
line (2) to the oil filter base.
4.
Connect hoses (5) and (6) to the cylinder block.
5.
Fill the cooling system with coolant to the
correct level.
6.
Start and run the engine. Make a check of the
engine oil level and add engine oil to the correct
level.
end by:
a) install crankcase guard
3-53
