TM 5-3825-226-24OIL FILTER BASE AND ENGINE OIL COOLERDISASSEMBLE OIL FILTER BASE AND ENGINE OILCOOLERstart by:a) remove oil filter base and engine oil cooler1.Remove the bolts that hold cover (1) to base(2). Remove the cover.2.Remove the three nuts that hold core (3) to thebase. Remove the core.3.Remove the cap and fitting (6), spring (5), andvalve (4) from the base.ASSEMBLE OIL FILTER BASE AND ENGINE OILCOOLER1.Install the valve, spring, fitting (3) and cap inbase (2). Tighten fitting (3) to a torque of 19 ± 4lb.ft. (25 ± 5 N-m). Tighten the cap to a torqueof 15 ± 4 lb.ft. (20 ± 5 N-m).2.Inspect the gasket that goes between the oilfilter base and the core. Install a new gasket ifneeded.NOTE:The gasket must be installed withpoint (4) (indexing point) in theposition shown.3.Install the core in the base. Install nuts (1).Tighten the nuts to a torque of 16 ± 2 lb.ft. (21± 3 N-m).4.Inspect the gasket that goes between the coreand cover (6). Install a new gasket if needed.5.Put the cover in position on the base. Installbolts (5).end by:a) install oil filter base and engine oil cooler3-54
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
