TM 5-3825-226-24EXHAUST MANIFOLDSREMOVE EXHAUST MANIFOLDSstart by:a) remove crankcase guardb) remove air cleaner housing and panelassembly (for right exhaust manifold)1.To remove the left exhaust manifold tilt the cab.See this procedure in REMOVE ENGINE.2.Remove nuts (1) and the bolts to disconnect theexhaust pipe assembly from the exhaustmanifold.3.Bend the tabs of locks (2) from bolts (3) andremove the bolts, locks, exhaust manifold (4)and the gaskets from the engine.INSTALL EXHAUST MANIFOLDS1.Put gaskets (2) and exhaust manifold (1) inposition on the engine.2.Put 9M3710 Anti-Seize Compound on thethreads of bolts (3) and install locks (4) and thebolts. Tighten the bolts to a torque of 32 ± 5lb.ft. (43 ± 7 N-m). Bend the tabs of the lockson the bolts.NOTE:Locks must be bent on a flat side ofthe bolt head. Bolts must be turnedno more than 30° of a turn for thealignment of the locks with a flat sideof the bolt head after they aretightened. Do not loosen the bolts tomake this alignment.3.Put exhaust pipe assembly (5) in position on theexhaust manifold. Put 9M3710 Anti-SeizeCompound on the threads of the bolts. Installthe bolts and nuts to hold the pipe assembly tothe manifold.4.Lower the cab see INSTALL ENGINE for thisprocedure.end by:a) install air cleaner housing and panelassembly (for right exhaust manifold)b) Install crankcase guard3-55
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
