TM 5-3825-226-24 TORQUE CONVERTER DISASSEMBLE TORQUE CONVERTER Tools Needed A B C D E 8B7548 Puller Assembly 1 T774 Spacer 1 8H663 Bearing Puller Attachment 1 8H684 Ratchet Box Wrench 1 2P8312 Retaining Ring Pliers 1 1P462 Drive Plate 1 9S289 Compressor 1 1P532 Handle 1 1P504 Drive Plate 1 1P507 Drive Plate 1 start by: a) remove torque converter 1. Remove    the    elevator    hydraulic    pump    and steering   and   water   distributor   hydraulic   pump from the torque converter. 2. Disconnect tube assembly (I) from the transmission  oil  pump.    Remove  four  bolts  (3) and transmission oil pump (2). 3. Remove  two  bolts  (5),  the  retainer  and  flange (4)  from  the  shaft.    Check  the  condition  of  the O-ring  seal  under  the  flange.    If  the  seal  has damage, use a new part for replacement. 4. Remove  six  bolts  (6)  that  hold  the  housing  to the carrier. 5. Install    two    3/8'"-16    NC    forged    eyebolts    in housing  (7)  as  shown.    Fasten  a  hoist  to  the housing and remove it.  It is necessary to hit the end of the shaft with a soft faced hammer until the  housing  is  free  of  the  bearing  on  the  shaft. Weight of the housing is 96 lb.  (43.5 kg). 3-160