TM 5-3825-226-24
BRAKE CONTROL VALVE
REMOVE BRAKE CONTROL VALVE
1.
Inside the cab, remove cotter in (3) and the pin
from the brake pedal (1)
2.
Remove the brake pedal and rubber cover (2)
from the top of the valve in position.
3.
Move the floor mat enough to remove three
screws (4) that hold the valve in position.
4.
From under the cab, disconnect tube and hose
assemblies (5) through (10) from the brake
valve.
NOTE:
Put identification on the tube and
lose assemblies as to their location -
or installation purposes.
5.
Remove the brake valve.
INSTALL BRAKE CONTROL VALVE
1.
Put the brake valve in position and connect tube
and hose assemblies (1) through (6) to their
correct locations on the valve.
3-276
