TM 5-3825-226-24
TURN AND STOP LIGHTS, WORK LIGHTS, WORK LIGHTS SWITCH
WARNING:
Disconnect
the
negative
battery
cable before any work is done.
REMOVE TURN AND STOP LIGHT
1.
Disconnect the leads (brown, red) at the back of
the lamp housing (1).
2.
Remove the two lockwashers and nuts (not
shown) that secure the housing to the mounting
bracket (2).
INSTALL TURN AND STOP LIGHT
1.
Install the two lockwashers and nuts that secure
the lamp housing (1) to the mounting bracket
(2).
2.
Connect the leads (brown, red) at the back of
the lamp housing (1).
REMOVE WORK LIGHT
1.
Disconnect the lead (brown) at the lamp housing
(3).
2.
Unscrew the nut (4) that secures the lamp
housing to the tank.
INSTALL WORK LIGHT
1.
Secure the lamp housing (3) to the tank with the
nut (4).
2.
Connect the lead (brown) at the lamp housing.
REMOVE WORK LIGHTS SWITCH
1.
Unfasten the electrical connector (1) for the
switch at the control panel (2).
2.
Remove the locknut (3) which secures the
switch (4).
INSTALL WORK LIGHTS SWITCH
1.
Install the switch (4) in the control panel (2) and
secure with the locknut (3).
2.
Fasten the electrical connector for the switch
(1).
6-38
